Error twenty-nine (29) means that your Roomba® was started while a software update was being performed.
Place your Roomba® on its dock for the software update to process fully. The software update shouldn't take more than a few minutes. You can also monitor the robot's status from the app.
If the Software update status continues indefinitely, please reboot by following these steps:
- From the app, navigate to Product Settings ➔ Reboot Roomba ➔ Reboot Roomba
- From the Robot, press and hold the power button for roughly 10 seconds
You should see a white light and hear a little tune. It may take up to a minute and a half for your robot to reboot. The reboot procedure is complete when the light ring shuts off.
|
Roomba® 100/1000, 200/2000, Plus 400, Plus 500, Plus 600, Max 700, and Max 800 Series
10 Seconds
Reboot the robot by holding down the power button on the robot for 10 seconds while it is off the dock. Hold the button again for 3 seconds to turn it back on.
|
If the robot is still stuck, unresponsive with an error 29, please remove and reinstall the battery, then test once more.
