Salesforce

Why is my Clean Base™ reporting a bag full after just a couple runs?

« Go Back
Article Details

The Clean Base™ disposal dirt bag also acts as a filter. Therefore, while the material does a great job of holding in dust and debris, it also has pores that allow air to travel through. As a result, if very fine particles have been picked up and evacuated, those fine particles could be blocking the pores of the bag. This causes the air pressure to increase and leads your robot to think there is a full bag, even if there is still room to hold more debris.

If that is the case, we suggest you give the bag a light shake to loosen the particles, or switch to a new bag if the problem persists.

For the same reason, you should not be reusing the bag, since the bag's pores could be already blocked from its initial use. Reusing the bag could lead to a higher chance of a "false bag full".

You can purchase replacement bags here.

To replace your Clean Base bag™:

  1. Lift up the lid of the canister lid to open.

  2. Pull up on the plastic card leading to the vacuum port and lift up to pull the bag out of the canister.

    Note: This will enclose the bag so no additional dust or debris can get out.

  3. Lightly shake the bag.

  4. Place the bag into the canister, sliding the plastic card into the guide rails.

  5. Press down on the lid, making sure it is firmly closed.


    Note:
    To achieve optimal performance with your robot and Automatic Dirt Disposal, clean and/or replace your robot's filter, as needed.

  6. Make sure the vacuum path isn't clogged.
 

Note: The newer models use a cardboard evac bag that is a bit larger and holds more debris. The original plastic bag is intended only for use with classic models. Please be sure you are using the correct bag for your model.

 
 
Original Plastic Evac Bag For classic models i, j, s, Essential and Combo 10 Max seriesOriginal Cardboard Evac Bag For Classic modelsNew Cardboard Evac Bag for any LiDAR-based robot operating on the new Roomba® Home App

 

Click here to see the full list of models that use the new bag.

 

  • Roomba® Mini + AutoEmpty™ Dock
  • Roomba® 100/1000 Series Vac + AutoEmpty™ Dock - NA only
  • Roomba® 100/1000 Series Combo + AutoEmpty™ Dock
  • Roomba® Plus 400 Series robot + AutoWash™ Dock
  • Roomba® Plus 500 Series robot + AutoWash™ Dock
  • Roomba® Max 700 Series Vac + AutoEmpty™ Dock
  • Roomba® Max 700 Series Combo + AutoWash™ Dock

 

 
Please visit the iRobot Store - Parts and Accessories or use an authorized retailer to order a part. If you believe you're in warranty, please contact iRobot Customer Care.

For customers outside North America, please visit Global.iRobot.com.
Information
Why is my Clean Base™ reporting a bag full after just a couple runs?
20953

Powered by