The Roomba® e Series essential care and maintenance procedures.

For optimal performance, please use these care procedures to keep the following Roomba e Series items cleaned.

• Front Caster Wheel
• Edge Sweeping Brush
• Cliff Sensors
• Charging Contacts & Docking Sensor Window
• Multi-Surface Brushes

Front Caster Wheel

Front caster wheels that are clogged with hair and debris could result in floor damage. Use the following procedure to maintain the front caster wheel.

1. Pull firmly on the front wheel to remove it.

2. Remove any debris from inside wheel cavity.

3. Spin the wheel by hand. If rotation is restricted, remove wheel from its housing and push firmly to remove the axle and clear any debris or hair wrapped around it.

4. Reinstall all parts when finished. Make sure the wheel clicks back into place.

Edge Sweeping Brush

1. Use a coin or small screwdriver to remove the screw.

2. Remove brush, clean the brush and brush post, and reinstall brush.

Cliff Sensors

Wipe the cliff sensors with a clean, dry microfiber or soft cotton cloth.

Charging Contacts

Check if there has been any buildup of debris or dirt on the charging contacts of the Home Base® and the robot. Unplug the base and wait 60 seconds. Then use a clean lightly dampened melamine foam, such as a Magic Eraser to remove debris from the charging contacts. The contacts should have a visible shine. 

Charging contacts on the Home Base®

Charging contacts on the robot

Multi-Surface Brushes Replacement

1. Open the cleaning head module door by pushing on the gray tab on the right side of the multi-surface brushes.

   

2. Match the shape of the multi-surface brushes pegs with the shape on the cleaning head module.

To get replacement parts, please visit the iRobot Store - Parts and Accessories, contact iRobot Customer Care, or use an authorized retailer or partner.

Cleaning Head Module Care

For optimal performance, the cleaning head module should be cleaned. Use the following procedure to maintain these items.

1. Open the cleaning head module door by pushing on the gray tab on the right side of the multi-surface brushes.

   

2. Remove the brushes from the robot and ensure hair and debris is removed from the square and hex pegs of the multi-surface brushes.

3. Clear debris on and under the gray bearings.

   

4. Insert the bearings on the multi-surface brushes.

5. Ensure the vacuum path is clear.

   

6. Match the shape of the multi-surface brushes pegs with the shape on the cleaning head module.